1.1本规范涵盖用于室外照明的增强热固性塑料灯杆。此类电杆可适用于电力和电信配电装置。 1.2电杆的设计参数应由买方和供应商商定，并应考虑产品安装和运输的预期使用条件。 1.3本规范包括地上或标准安装高度为10英尺（3.05米）至50英尺（15.24米）的电杆。涵盖了两类极点，一类是标准设计，另一类是刚性设计。 1.4以英寸-磅为单位的数值应视为标准值。括号中显示了等效的国际单位制。 1.5以下预防性警告仅适用于本规范第10节的试验方法部分: 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，并确定监管限制的适用性。

1.1 This specification covers reinforced thermosetting plastic poles used for outdoor lighting. Such poles may be applicable to electric power and telecommunication distribution installations. 1.2 The design parameters of the poles shall be agreed upon by the purchaser and supplier and should take into consideration the anticipated service conditions of installation and transportation of the product. 1.3 This specification includes poles with above-ground or standard mounting height of 10 ft (3.05 m) through 50 ft (15.24 m). Two classes of poles are covered, one of standard design, the other of stiff design. 1.4 The values stated in inch-pound units are to be regarded as standard. Equivalent SI units are indicated in parentheses. 1.5 The following precautionary caveat pertains only to the test methods portion of this specification, Section 10: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.