作废
ASTM F2307-03
到馆提醒
收藏跟踪
分享链接
购买正版
选择购买版本
本服务由中国标准服务网提供
更多
前往中国标准服务网获取更多购买信息
支持批量购买纸质版标准
Standard Specification for Series 10 Poly(Vinyl Chloride) (PVC) Closed Profile Gravity Pipe and Fittings Based on Controlled Inside Diameter (Withdrawn 2011)
基于受控内径的系列10聚氯乙烯(PVC)封闭型重力管和配件的标准规范(2011年撤销)
发布日期:
2003-08-10
废止日期:
2011-08-03
1.1本规范涵盖了10 psi管道刚度聚氯乙烯(PVC)闭式剖面污水管和配件的要求,这些管道和配件具有整体钟形和弹性密封接头,或具有尺寸(18至60英寸)联轴器的平端管基于受控内径。
1.2以英寸-磅为单位的数值应视为标准值。括号中给出的值仅供参考。
1.3以下安全危险警告仅适用于本规范第节试验方法部分:
本标准并非旨在解决与其使用相关的所有安全问题(如有)。本标准的用户有责任在使用前制定适当的安全和健康实践,并确定监管限制的适用性。
注1:根据本规范生产的管道和管件应按照规程D 2321进行安装。
1.1 This specification covers requirements for 10 psi pipe stiffness poly(vinyl chloride) (PVC) closed profile sewer pipe and fittings with integral bell and elastomeric seal joints or plain end pipe with couplings in sizes (18 to 60 in.) based on a controlled inside diameter.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazard caveat pertains only to the test methods portion, Section, of this specification:
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1—Pipe and fittings produced to this specification should be installed in accordance with Practice D 2321.