1.1 本试验方法包括使用水分平衡分析仪快速定量测定乳化沥青结合料中的残留物。它适用于所有不含溶剂的乳液类型。 1.2 以SI单位表示的值应被视为标准。 1.3 由于尚未制定本标准的完整精密度和偏倚声明，因此该测试方法仅用于研究和信息目的。因此，本标准不应用于接受或拒绝采购材料。 1.4 本标准并不旨在解决与其使用相关的所有安全性问题（如果有）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践并确定法规限制的适用性。1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。 ======意义和用途====== 4.1 本试验用于指示乳化沥青结合料的组成特性，适用于说明书表1所述的阴离子乳化沥青结合料 D977 和如说明书表1所述的阳离子乳化沥青粘结剂 D2397/D2397M 含溶剂乳液除外。还可以对从该测试方法获得的残余物进行流变学表征。 3 附注1: 本标准产生的结果的质量取决于执行该程序的人员的能力以及所用设备的能力、校准和维护。符合规范标准的机构 D3666 通常被认为能够胜任和客观的测试、取样、检查等。本标准的使用者应注意符合规范 D3666 单独并不能完全确保可靠的结果。可靠的结果取决于许多因素；遵循规范的建议 D3666 或者一些类似的可接受的指南提供了评估和控制这些因素中的一些的方法。

1.1 This test method covers a rapid and quantitative determination of the residue in emulsified asphalt binder using a moisture balance analyzer. It is applicable to all nonsolvent-containing emulsion types. 1.2 The values stated in SI units are to be regarded as the standard. 1.3 Since a complete precision and bias statement for this standard has not been developed, the test method is to be used for research and informational purposes only. Therefore, this standard should not be used for acceptance or rejection of a material for purchasing purposes. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 This test is used to indicate the compositional characteristics of emulsified asphalt binder and is applicable to anionic emulsified asphalt binder as described in Table 1 of Specification D977 and cationic emulsified asphalt binder as described in Table 1 of Specification D2397/D2397M except solvent-containing emulsions. The residue obtained from this test method may also be subjected to rheological characterizations. 3 Note 1: The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors.